XCell D94 Скачать руководство пользователя страница 7

Страница: 7 / 11

i94 Intelligent Automatic Battery Charger

E&OE

Operation

Substances used in batteries and gases or vapours produced when charging

may be extremely flammable – keep clear of naked flames or other ignition

sources. • Correct battery polarity MUST be followed. Incorrect polarity may present an explosion or fire

hazard. • Do NOT attempt to charge a frozen battery. •

Do NOT connect to or charge the battery of a running

engine

. • Do NOT connect the battery connect clamps to any part of the fuel system or sensitive electrical

components. • Position all charger cables so they cannot come into contact with conductive parts of the

vehicle (except the battery terminals), be pinched or caught etc. • Always select the correct voltage of the

battery being charged. Do NOT charger a battery using a different voltage to the battery rating. • Always

follow battery manufacturer instructions for battery charging. • If applicable, before charging, remove any

battery cell ventilation caps and check that the cell electrolyte level is adequate. After charging, check

electrolyte level and re-install battery cell ventilation caps.

Using Charging Cables

The charging (output) cables are colour-coded for polarity –

RED

POSITIVE

and

BLACK

NEGATIVE

There are two types of cable supplied:

•

Permanent Battery Connect Cable

– For convenient, regular charging. To use,

attach the connectors on the ends of the cable directly to the battery terminals. To

use, connect the free end of the cable to the battery charger output cable.

•

Terminal Clamp Battery Connect Cable

– For connecting directly to the

corresponding battery terminals. To use, squeeze the clamp to open the jaw, then

place the jaw over the battery terminal and release the clamp. Ensure that the

clamp is firmly attached to the battery terminal.

•

12V Vehicle Socket Connect Cable

– For connecting to the battery using the

vehicle electrical system. This is the simplest and least complicated method. To

use, insert the 12V plug connector into the vehicle 12V / cigarette lighter socket.

Note

: The vehicle 12V socket must remain "on" when the vehicle ignition is "OFF".

To connect either battery connect cable to the charger, firmly push the ends

of the battery connect cable and charger output cables together (they can fit

one way only).

Charging a Battery

1. If using the terminal clamp battery connect cable, connect the

POSITIVE

clamp to the battery

POSITIVE

terminal, the connect the

NEGATIVE

clamp to the battery

NEGATIVE

terminal.

2.  Connect the battery charger output cable to the battery connect cable.
3.  Connect the charger to a 240VAC electrical supply and switch the supply ON. The display illuminates.
4.  Use

MODE

to select the required charging program. Once a mode has been selected, the charger

begins charging the battery.

To stop charging:
1.  Switch the electrical supply to the charger OFF, then disconnect the charger power cable.
2.  Disconnect the battery connect cable from the battery charger output cable.
3.  If using the terminal clamp battery connect cable, remove the clamp from the

NEGATIVE

terminal, then

remove the clamp from the

POSITIVE

terminal.

XCELL