Xantrex XW4024-120, Руководство по эксплуатации

Страница: 30 / 112

Monitoring Operation
2–8 975-0240-01-01
Using the Standby Button
The Standby button has two functions, depending on how it is pressed. The
Standby button can disable inverting and charging for all XW Inverter/Chargers in
the system, or, when pressed simultaneously with the Exit button, put the entire
system into Standby mode.
Pressing the Standby button produces the same result as disabling “Invert” and
“AC Charge” from the System Settings menu on the XW System Control Panel.
Pressing the Standby button momentarily affects only XW Inverter/Chargers; it
does not affect Charge Controller operation. After disabling inverting and
charging with the Standby button, the system continues to pass AC input through
to the loads, and “– – –” is displayed on the Inverter Information Panel.
Pressing the Exit and Standby buttons at the same time puts the entire XW power
system (including Charge Controllers) into Standby mode. In Standby mode, the
XW Inverter/Chargers stop passing AC input through to the loads, and “Stb” is
displayed on Inverter Information Panel.
After the keypress command to enter Standby mode, the XW-AGS (if installed)
shuts down the generator (if it is running) after a cool-down cycle.
System Control Panel Navigation
This section describes the different types of screens and menus on the System
Control Panel. To monitor XW Inverter/Charger operation, it is helpful to know
how to locate these screens and menus.
Viewing the System Control Panel Home Screens
The top level screens on the System Control Panel are the Startup screen, the
System Status screen and the Device Home screens. After power is applied and
the Startup screen appears, the System Control Panel displays the System Status
screen. The Device Home screens for the XW Inverter/Charger and other devices
in the system can be viewed by pressing the up and down arrows, as shown in
Figure 2-3.