Xantrex Watt Series Programmable DC Power Supply XG..., Руководство по эксплуатации

Страница: 75 / 286

Using the External Shutdown Function
M370078-01 3-31
3
Defining the Polarity of the External Shutdown Signal
1. Turn the 9-position mode control to the PRT position or press the
rotary Adjust/Enter control if the control knob is already at the PRT
position.
PrO OUP is displayed on the output voltage display.
2. Turn the rotary Adjust/Enter control until PrO SD is displayed.
3. Press the rotary Adjust/Enter control to display SD 0 (shutdown on
logic 0) or SD1 (shutdown on logic 1).
4. Press the rotary Adjust/Enter control to commit the desired polarity
setting.
For example: If you set the shutdown logic to 1 (
SD1 ) and apply a
logic high (greater than 1.2 Vdc) to pin J3.12 relative to pin J3.6 on
the ISOL connector, the power supply will shut down. Conversely, if
you set the shutdown logic to 0 (
SD0 ), the power supply will only
operate when you have a logic high (greater than 1.2 Vdc) to pin J3.2
relative to pin J3.6.
The SCPI command (s) for these instructions are:
[:]OUTPut[<channel>]:POLarity
Important:
There is an internal pullup resistor inside the shutdown circuit so
the shutdown polarity should be set to 0 if it is not being used.