975-0697-01-01
41
Installing the Inverter/Charger
This guide for use by qualified installers only.
Step 8: Testing Your Installation
There are several tests to be performed for testing your
installation. These tests will verify that:
•
the Freedom SW 230V works in invert mode,
•
the Freedom SW 230V works in charge mode, and
•
the Freedom SW 230V works in AC bypass mode.
If the test fails at any point, go to “Step 7: Performing Checks
Prior to Initial Start-Up” on page 40 and go through the
checklist again to check the installation. Then perform the test
again. If the test fails again, see the troubleshooting section in
the Freedom SW 230V Sine Wave Inverter/Charger Owner’s
Guide.
Testing in Invert Mode
To test the Freedom SW 230V in invert mode, using a 100
watt light bulb as the test load:
1. Close the DC disconnect switch or the DC circuit breaker
to supply DC power to the Freedom SW 230V.
Wait for all the lights on the front panel to flash on and
off, indicating that the unit has successfully initialized (10
to 30 seconds).
ELECTRICAL SHOCK HAZARD
The Inverter Enable button on the Freedom SW 230V and the optional
accessories do not disconnect DC or AC input power to the Freedom SW
230V.
Failure to follow these instructions can result in death or serious injury.
Figure 15
Freedom SW 230V Front Panel
XANBUS INTERFACE
STACKING
FREEDOM
SW
INVERTER/CHARGER
CLEAR FAULT
RESET
INVERTER
ENABLE
INVERTER
ENABLED
AC IN
FAULT
GEN
SUPPORT
CHARGING WARNING
FSW 230V Installation Guide.book Page 41 Tuesday, August 7, 2018 9:18 AM
