33
32
DE
EN
IT
FR
on and switches slowly between red, green, blue and yellow.
» When music is played, the party light automatically reacts to it.
» To turn off the party light press the button again for about 3
seconds.
» The party light can be used with and without music, as well as it‘s
possible to play music without the party light switched on.
WARNING!
You must not, under any circumstances, look
directly into the emitted light as this may cause permanent
damage to your eyes. Never point the LED light directly towards
other people or animals.
People suffering from photo-sensitive epilepsy, are susceptible to
epileptic seizures or loss of consciousness if exposed to flashing
lights or light patterns. If symptoms such as dizziness, blurred
vision, eye or muscle twitching, loss of awareness, disorientation,
any involuntary movement or convulsion should occur, the light
effect should be switched off or the person should leave the room/
place.
Connecting a Microphone
» The unit is equipped with one 6,3 mm microphone socket, that can
be used with or without music.
» Please read and follow all safety instructions and manuals
carefully that are provided with the microphones.
» It is not possible to connect condenser microphones.
» Connect the microphone with the MIC jack to the unit.
» Switch on the microphone according to the manual of the
manufacturer.
» Turn on the unit as described in chapter „ON/OFF“.
» Regulate the volume with MIC VOLUME and VOLUME to an approp-
riate sound level.
» Now you can speak or sing into the microphone.
DANGER!
Take care that you don’t place the microphone too
close to the speaker – otherwise an acoustic feedback
(squealing from the speakers) can happen. Higher settings of the
microphone volume will result in greater sensitivity for acoustic
feedbacks.
Connection via AUX-IN
» Plug the provided 3,5 mm cable into the socket of a personal media
player like the headphone input of your smartphone and plug the
other end into the AUX-IN jack of the unit.
» Turn on the unit as described in chapter „ON/OFF“.
» Start the music on the personal media player. The loudspeaker
will immediately start the playback. To switch between tracks, use
your personal media player. To pause the track press >|| shortly. To
switch modes press the mode button shortly.
Trouble shooting
Error
Solution
The loudspeaker does not turn on
after pressing the power button.
Check if the battery is suffi-
ciently charged. If not, recharge
the battery completely and try
again turning on the product
afterwards.
The loudspeaker turns off after
pressing the power button.
No bluetooth connection can be
set up (no music is played).
Check if you chose the correct
bluetooth device. PCs support
A2DP.
The music is very low.
Check if the volume is set
properly and adjust it with
-VOL+.
