20
»
Open up the battery compartment of the remote control.
»
Put in 2x AAA batteries. Please take care of the correct
polarity.
»
Put on the cover of the battery compartment again.
»
Slide the mounting bracket back onto the remote control if
needed.
»
Pick an appropriate place to put on the lamps and mounting
bracket. This place must not be over a sink, the stove or
other fire places.
»
Clean the chosen place thoroughly. It must be free from
grease, clean, dry and even.
»
Remove the protection from the adhesive point at the rear of
each lamp and the mounting bracket.
»
Press each lamp and, if needed, the mounting bracket
against the mounting surface for about 10 seconds.
»
The light set is now ready for use.
The lamps can be controlled via the remote control or by
direct push on the illuminated area.
Remote Control:
»
Press 4: The lamps will be illuminated on high intensity.
»
Press 5: The brightness will be lowered. To increase the
brightness again, press 5.
»
Press 6: A 30 minutes timer will be activated.
Содержание 701755
Страница 2: ...2 A B C 1 4 6 3 5 3 D...