X10 Wireless Technology, Inc. Limited One Year Warranty
X10.com, a division of X10 Wireless Technology, Inc. (X10) warrants X10
products to be free from defective material and workmanship for a period of
one (1) year from the original date of purchase at retail. X10 agrees to repair
or replace, at its sole discretion, a defective X10 product if returned to X10
within the warranty period and with proof of purchase. If service is required
under this warranty:
Call 1-800-442-5065, visit www.x10.com, or e-mail [email protected].
For help or more information on setup, please visit:
http://www.x10.com/support
PH508-04/03
POWERHORN
™
Remote Siren, Model PH508
INSTALLATION AND OPERATING INSTRUCTIONS
1. Set the Housecode dial on the
POWERHORN
to the same letter as your
security system (Model DS7000, or DC8700).*
2. If you want to control the
POWERHORN
from other types of X10
controllers, set the Unit Code dial on the
POWERHORN
to any unused
number between 1 & 16.*
3. Plug the
POWERHORN
into an AC outlet (not one that is controlled by
a wall switch, in case the switch accidentally gets turned off).
4. To test the
POWERHORN
, trip your alarm system. The
POWERHORN
will sound for as long as the alarm in the security system console sounds,
and then shut off a few seconds after you disarm the alarm.
WARNING:
The
POWERHORN
is extremely loud. To avoid permanent hearing
damage, do not stand too close to it when you trip the alarm.
5. To trip the
POWERHORN
from any X10 controller (if you hear a strange
noise at night, for example): Press Unit Code-ON, then Unit Code-OFF,
then Unit Code-ON, repeatedly. The
POWERHORN
will sound for as
long as you keep pressing ON and OFF and will stop a few seconds after
you stop pressing buttons. Or press All Lights On, then All Units Off,
repeatedly. The
POWERHORN
will sound for as long as you keep
pressing All Lights On, followed by All Units Off and will stop a few
seconds after you stop pressing buttons.
* Note: If you have a DC8700 security system it might be set to flash lights
set to Unit Code 13. If that is the case set the
POWERHORN
to Unit Code
13.
Powerhorn™
1
9
5
13
15
3
7
11
•
•
•
•
•
•
•
A
I
E
M
O
C
G
K
•
•
•
•
•
•
•
•
Set the Housecode to
the same letter as your
X10 Controllers and/
or Security System.
Set the Unit Code to
any unused number
(set to 13 if you have
a DC8700 Security
System).
