10
X GLOO
®
•
Windeckstr. 4
•
83250 Marquartstein
•
Germany
• Next, pull the check valve tab forward (c) before filling
any remaining space in the barrel with air. It is not
necessary to connect the pump directly to the top
opening. Instead, the easiest way is to hold the hose
of the running pump against the edge of the check
valve in the upper opening (d).
• Finally, tightly close the cover on the upper opening
(e).
• To transport the Water Ballasting Barrel, either lift it
by the handles with two people or tip it onto the hard
bottom edge and roll it.
4.2.2 CONNECTING
The eyelets on the base of the Water Ballast Barrels
can be used to connect them to the rings on the tube
ends by means of the included shackles. You can at-
tach up to two Water Ballast Barrels directly to the
rings on the tent base.
4.2.3 EMPTYING
To empty the barrels, unscrew the cover on the bottom
opening and push in the check valve tab so that the
water can run out by itself.
4.2.4 DIGITALLY-PRINTED COVER
The digitally-printed cover can be pulled completely
over the filled barrel and then zipped closed.
4.3 TENT STAKES
When using tent stakes, it should be noted that the actual anchoring strength achieved
depends largely on the nature of the ground surface. Because of this, no general information
can be provided about which wind loads can be absorbed with which number of stakes.
It is always important to drive in the tent stakes an angle slightly toward the tube end to help
prevent them from being pulled out in windy conditions.
d
e