WWBeds Face Unassembled Alpha Murphy, Руководство по сборке, Страница: 5 / 18

Mounting Lift Mechanism
Video: ​ ​ Mounting the Lift Mechanism
NOTE: Some models may have the Lift Mechanism already
mounted to the verticals. If this is the case with your
Murphy bed than you can skip this section.
2-1. The left and right Lift Mechanism hole pattern will line
up with the hole pattern on the Side Panels (B). The bolts
will be fed through the side that has the counter sink holes
drilled.
2-2 Hole A will not have a standard nut. It is either a
threaded hole or it will use a disk like bolt “Arm Lock Stop”.
Get Hole A started.
2-3 Insert the bolt in the other holes and loosely tighten
onto the nuts.
2-4. Once all Bolts and Nuts have been started tighten all of
them.
Assemble the Bed Cabinet
Video:
​
The Cabinet Part 1
● If possible, the Bed Cabinet should be
assembled in the room where it will be
used.
● Be sure Lift Mechanisms are securely
installed.
Headboard and Top Panel Installation
On a soft surface like a blanket lay out the
verticals.
3-1. Insert the headboard dowels into the
ends of the headboard (two on each side). No
need to measure, The dowels will align the
headboard to where it needs to be. With the
pocket screw holes facing toward the back,
insert the headboard dowels into the side of
the verticals.