wtw DIQ/S 182-PR, Руководство по эксплуатации системы

Страница: 47 / 146

System 182 Installation
3 - 33 ba75503e07 04/2012
3.8.2 DIQ/S 182-PR/24V (24 V version)
Warning
If the 24 V AC/DC supply is incorrectly connected, it may
represent a danger to life from electric shock. Pay attention to the
following points during installation:

The DIQ/S 182-PR Universal Transmitter may only be
connected by a trained electrician.

The 24 V AC/DC supply must meet the specifications quoted on
the name plate and in chapter 10 T
ECHNICAL DATA
(protective low
voltage SELV).

The connection of the DIQ/S 182-PR Universal Transmitter to
the power supply may only be carried out when it is not
carrying any voltage.

When installed in a building, a switch or power switch must be
provided as an interrupt facility for the System 182.
The interrupt facility must
– be installed in the vicinity of the DIQ/S 182-PR Universal
Transmitter, easily accessible by the user, and
– be labeled as the interrupt facility for the DIQ/S 182-PR
Universal Transmitter.
Note
Rechargeable battery systems should have a deep discharge
protection. The DIQ/S 182-PR/24V does not have any built-in deep
discharge protection.
Materials required

Wire end sleeves, suitable for the 24 V AC/DC feed line, with
suitable crimping tool

1 x screwed cable gland with sealing ring (scope of delivery of the
Universal Transmitter).
Tools

Cable stripping knife

Wire stripper

Phillips screwdriver

Small screwdriver.
Preparing the 24 V AC/
DC line
1 Cut off the cable to the required length.
2 Strip the cable insulation for approx. 45 mm.
3 Bare the wires 1 and 2 and fit them with wire end sleeves.