wtw DIQ/S 182-MOD, Руководство по эксплуатации системы

Страница: 71 / 150

System 182 Operation
4 - 11 ba75504e07 04/2012
4.4.3 Sensor status Sxx
In the SENSOR STATUS Sxx menu you can prompt the following
information on a sensor:

Type and series number

Software status

Error and info messages ("log book")

Data of the last calibration (only for sensors that can be calibrated)
Fig. 4-8 SENSOR STATUS Sxx
Log book The log book is a list of messages related to a sensor. If there is a new
message the info or error symbol in the header of the measured value
display flashes:
If there are info and error messages present at the same time, the error
symbol
h
flashes (more important).
The flashing of the info or error symbol only stops after all detailed
message texts in the log book have been opened and marked with a
tick (

). The operating sequence to do this is described on page 4-13.
Note
The error symbol also flashes if the operational voltage or
communication in the system are faulty. You can check this in the
PROPERTIES / SYSTEM STATUS menu (see section 4.4.1).
h
Flashes if a new or unacknowledged error message is present
in the log book that requires immediate action.
i
Flashes if a new or unacknowledged informational message is
present in the log book.