wtw DIQ/S 181, Руководство по эксплуатации, Страница: 48 / 104

Operation
DIQ/S 181
48
ba77083e01 02/2015
4.3.2 Setting tables
The actual settings are made in the setting tables. Each setting is rep-
resented by two lines together. The name of the setting appears in the
upper line on the left side of the display. The corresponding value is in
the line below on the right side.
Fig. 4-3 Example of a setting table
Operating notes:

The arrows
8
/
2
appear if further display setting options are above
or below the visible display range.

The toggle switch <

> is used to highlight a setting (displayed in
reverse video) and move the visible display range up or down.

To edit a setting, highlight it and press <OK> . The line below is high-
lighted and switches to the entry mode. Depending on the operating
situation, a new submenu or a table with further relevant settings
can open up.

Break off an action and change to the next higher level with the
<ESC> key.

Move directly to the measured value display with <M> .
Fig. 4-4 Save and quit
To accept all settings, highlight the Save and quit menu
item at the lower end of the setting table and press <OK> .
If you exit the setting table via <M> , <ESC> / or the Quit
menu item, all changes are ignored.