Firmware update
Cond 3310 IDS
52
ba77051e04
07/2017
12.2 Firmware-Update for IDS Sensors
With the "Firmware Update" program and a PC you can update the firmware of
an IDS sensor to the newest version.
You can find available firmware update files for your IDS sensor on the Internet.
For updating, connect the IDS sensor to the Cond 3310 IDS, and the
Cond 3310 IDS to a PC.
For the update via the USB-B interface, the following is required:
a free USB interface (virtual COM port) on the PC
the driver for the USB interface (on the enclosed CD-ROM)
the USB cable (included in the scope of delivery of the Cond 3310 IDS).
After switching the meter off and on you can check whether the sensor has
taken over the new software version (see Y
48).
1.
Install the downloaded firmware update on a PC.
An update folder is created in the Windows start menu.
If an update folder already exists for the sensor (or sensor type), the new
data are displayed there.
2.
In the windows start menu, open the update folder and start the firmware
update program for the IDS sensor
3.
Connect the IDS sensor to the Cond 3310 IDS meter.
4.
Using the USB interface cable, connect the Cond 3310 IDS to a USB
interface (virtual COM port) of the PC.
5.
Switch on the Cond 3310 IDS.
6.
In the firmware update program, start the update process with OK.
7.
Follow the instructions of the firmware update program.
During the programming process, a corresponding message and a prog-
ress bar (in %) are displayed.
The programming process takes up to 5 minutes. A terminatory mes-
sage is displayed after a successful programming process. The firmware
update is completed.
8.
Disconnect the Cond 3310 IDS from the PC.
Meter and sensor are ready for operation again.
Содержание Cond 3310 IDS
Страница 6: ...Contents Cond 3310 IDS 6 ba77051e04 07 2017...
Страница 56: ...Index Cond 3310 IDS 56 ba77051e04 07 2017...
Страница 57: ......