5-4
Basic Configuration
5.2. Configuration Menus
Although the Web Browser Interface and Text Interface provide two separate means for
selecting parameters, both interfaces allow access to the same set of basic parameters,
and parameters selected via one interface will also be applied to the other. To access
the configuration menus, proceed as follows:
•
Text Interface:
Refer to the Help Screen (/H) and then enter the appropriate
command to access the desired menu. When the configuration menu appears, key
in the number for the parameter you wish to define, and follow the instructions in
the resulting submenu.
•
Web Browser Interface:
Use the links and fly-out menus on the left hand of the
screen to access the desired configuration menu. To change parameters, click in
the desired field and key in the new value or select a value from a pull-down menu.
To apply newly selected parameters, click on the "Change Parameters" button at the
bottom of the menu or the "Set" button next to the field.
The following sections describe options and parameters that can be accessed via each
of the configuration menus. Please note that essentially the same set of parameters and
options are available to both the Web Browser Interface and Text Interface.
Notes:
• Configuration menus are only available when you have logged into command
mode using a password that permits Administrator Level commands.
SuperUser accounts are able to view configuration menus, but are not
allowed to change parameters.
• Configuration menus are not available when you are communicating with the
RSM-8R via PDA
• When defining parameters via the Text Interface, make certain to press the
[Esc]
key several times to completely exit from the configuration menu
and save newly defined parameters. When parameters are defined via the
Text Interface, newly defined parameters will not be saved until the "Saving
Configuration" message has been displayed and the cursor returns to the
command prompt.