10-5
Telnet & SSH Functions
10.3.4. Terminating a Direct Connect Session
To terminate a Direct Connect session, use the client program’s "disconnect" feature.
The following will occur immediately upon a client initiated disconnect:
1. The Network port is disconnected from the serial port.
2. The Network session is terminated.
3. The serial port is put to sleep.
Notes:
• The Sequence Disconnect Command, which is defined via the Port
Configuration menus, cannot be used to terminate a Direct Connection.
• Any RSM-8R port that allows Administrator or SuperUser level commands can
terminate a direct connection at another port by issuing the /D command as
described in Section 9.3.1.2.
• Acknowledgment of data received by the RSM-8R network port does not
automatically indicate that the data has been completely sent out the serial
port. Data may still be queued in RSM-8R buffers. Any data queued at the
time of a client initiated disconnect is discarded, and is not passed to the
attached device.