13-5
Operation via SNMP
13.4.2. Plug Group Status/Control
ON, OFF, BOOT, and DEFAULT commands can be issued for plug groups via SNMP.
Plug groups are arranged in a table of 54 rows, one row for each plug group in the
system. Plug Group parameters are described below.
•
plugGroupTable::plugGroupName
– String indicating the plug groups name.
•
plugGroupTable::plugGroupAction
– Action to be taken on plug group
1
– Mark to turn ON (does not execute)
2
– Mark to turn OFF (does not execute)
3
– Mark to BOOT (does not execute)
4
– Mark to DEFAULT (does not execute)
5
– Mark to turn ON and execute plug group actions
6
– Mark to turn OFF and execute plug group actions
7
– Mark to BOOT and execute plug group actions
8
– Mark to DEFAULT and execute plug group actions
Set
plugGroupTable::plugGroupAction
to desired action, as specified by values
1-4 above, for each plug group index the action is to be applied to. For the last plug
group you wish to set before executing the commands, use values 5-8 instead, which
will invoke the requested commands all at once.
•
plugGroupTable::plugGroupCurrent
– The current, in tenths of an Amp, that
is being consumed by each Plug Group.
•
plugGroupTable::plugGroupPower
– The power, in Watts, that is being
consumed by each Plug Group.
