Page 8
Rev. 2/2022
www.willoughbystainlessfountains.com
Installation & Operation Manual
Outdoor Pet Drinking Fountain
WODF-1-PET Series
Willoughby Stainless Fountains
TOLL FREE
(800) 428-4065
● LOCAL
(317) 875-0830
● FAX
(317) 875-0837
Installation Instructions
Step 1: Fixture Installation
Note: the WOPF-1 outdoor fountain is to be mounted on a flat, level surface
(concrete or otherwise) with an adequate support structure.
Note: refer to Rough-In Dimensions for locating plumbing connections.
1�)
Install service shut-off valve in water supply line (valve not furnished).
2�) Locate and install drinking fountain using 1/2"-13 x 4" stainless steel concrete anchors (anchors
not furnished)�
3�)
As noted previously, flush the water supply line with clean drinking water before making final
connections to the drinking fountain�
4�)
Connect water supply line to inline strainer inside drinking fountain using 3/8" plastic tubing
(extra tubing not furnished). Push tube straight into fitting on filter about 3/4" until it reaches a
positive stop� Water supply connection must comply with local codes�
5�)
Connect fountain drain line to drainage system. Drain is to be 1-1/2" IPS minimum to a porous
gravel flll or main sewer line located below frost line. Installer to provide waste trap downstream
of drain connection� Drain and waste trap must comply with local codes�
6�) Turn on water supply and check both the water supply lines and drain lines for leaks�
Installation Instructions