WPG MR1611LDC, Инструкция по эксплуатации

Страница: 17 / 46

Rev 34.7/3-20 15 MR1611LDC: #35050
Sealing the Pads against the Load
The “attach/release” switch is located on the movable control pendant. The pendant allows the
vacuum controls to be moved away from the lifter, so that the operator can control airflow at a
distance equal to the length of the pendant cord.
WARNING: Do not disconnect control pendant during lifter operation.
The control pendant is not intended to be disconnected during lifter operation. Disconnecting the
control pendant is likely to result in a load release and injury to the operator or others nearby.
Turn the “attach/release” switch to the “attach” ( ) position (clockwise) to make sure the
“attach” function is activated.
WARNING: Keep “attach/release” switch in “attach” position throughout lift.
Alternatively, if the lifter is equipped with a Remote Control System, press the “attach” button
( ) on the radio transmitter.
This energizes the vacuum pumps, causing air to be drawn immediately at the vacuum pads.
The low vacuum warning buzzer also sounds an alarm until the lifter attains sufficient vacuum to
lift the maximum load weight (see T
O
L
IFT AND
M
OVE THE
L
OAD
: Load Capacity and Lift Light to
follow). Press the lifter onto the load until all the pads seal against it. The lifter must remain in
the “attach” mode throughout the entire lift.
Note: If a vacuum pad has been lying against a hard object (as during shipping), it may be
slightly distorted. Although initially it may be difficult to attach the pad to a load, this condition
should correct itself with continued use.