Worx WX041, Руководство по эксплуатации

Страница: 8 / 12

8
10. WeldING plAStIcS
Place on the reduction nozzle and the welding shoe.
The materials to be welded and the welding rod must
be made of the same material (e.g. PVC with PVC).
The seam must be clean and grease-free. Heat the
welding seam until it becomes tacky. Please note that
the temperature difference between the tacky and liquid
state of a plastic is very small. Then feed in the welding
rod and allow to run into the gap so that a uniform
bead is produced.
11. beNdING plAStIc tube (See fig. c)
Choose the hook nozzle and fit over heat outlet. Turn
the gun upside down and place on its clip stand so that
it is resting on a secure bench with the nozzle pointing
upwards, see picture. To avoid buckling or kinking the
tube, fill the tube with dry sand and seal at both ends.
Heat the tube evenly by moving from side to side and
bend to required shape.
WARNING:
Protect hands from heat.
MAINTENANCE
Remove the plug from the socket before carrying out
any adjustment, servicing or maintenance.
There are no user serviceable parts in your power
tool. Never use water or chemical cleaners to clean
your power tool. Wipe clean with a dry cloth. Always
store your power tool in a dry place. Keep the motor
ventilation slots clean. Keep all working controls free
of dust. Occasionally you may see sparks through the
ventilation slots. This is normal and will not damage
your power tool.
If the supply cord is damaged, it must be replaced by
the manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard.
A
3
C
B