Worx WX041, Руководство по эксплуатации

Страница: 7 / 12

7
The ideal temperature should first be ascertained
by performing a test. Therefore, begin with a lower
temperature setting.
All application examples (except
Removing paint
from Window frames
) can be performed without
accessories. However, the use of the recommended
accessory part simplifies the work and significantly
improves the quality of the results.
Be careful when changing the nozzle, danger of
burning!
do not tough the hot nozzle. Allow the
unit to cool. Wear protective gloves.
5. ScRApeR (See fig. b)
The scraper is ideal for stripping paint from flat
wooden surface and edges.
Remember to clean the blade after use with wire wool
and lightly oil before storing.
6. RemovING pAINt
Choose the required nozzle and fit onto the heat outlet.
Soften the paint using hot air and remove evenly using
a spatula. Do not heat the paint for too long since this
will burn the paint, making it more difficult to remove.
7. RemovING pAINt fRom WINdoW fRAmeS
danger of glass breaking!
Use of the glass protection nozzle is essential. On
profiled surfaces, paint can be removed using a spatula
and brushed off using a soft wire brush.
8. defRoStING fRozeN pIpeS
Water lines often do not differ in appearance
from gas lines. Gas lines are not to be heated
under any circumstances.
Place on the reflector nozzle. Heat the frozen zone
always from the outside to the middle.
Warm plastic pipes as well as connections between
pipe pieces especially carefully to prevent damage.
9. SHRINk SeAtING electRIcAl cAbleS
Place on the reduction nozzle. Select the diameter of
the heat-shrink tubing according to the work piece, for
example, a cable lug. Heat the heat-shrinkable sleeve
evenly.
Many adhesives (e.g. stickers) become softer when
heated allowing adhesive bonds to be separated or
superfluous adhesive to be removed.
A
3
C
B