MADANT DARSHEL PTY LTD
PO Box 242 Salisbury Queensland Australia 4107
Phone: +61 7 3277 7866
Fax: +61 7 3277 2385
INSTALLATION INSTRUCTIONS
PART NUMBER:
WR 233
WORX INTAKE GRATE
YAMAHA 09 FZR, FZS
IMPORTANT: READ ALL INSTRUCTIONS BEFORE PROCEEDING WITH INSTALLATION
Parts Supplied: 1 x
Worx Intake Grate
1 Remove stock intake grate and wipe clean any old silicone or Loctite from hull and
threaded inserts
2.
Fill threaded inserts with silicone and apply a small amount of silicone to the front mounting surface and a
generous amount of silicone to the rear mounting surface and edges of your new
Worx
Intake Grate
3.
Fit
Worx
Intake Grate into position using the stock mounting bolts.
4 Wipe off excess silicone with a damp cloth. Allow 4-6 hours minimum for silicone to cure before riding.
5.
Regularly check that all bolts are tight on your intake grate and ride plate.
6.
Regularly check the condition of your intake grate after use.
Thank you for purchasing
Worx Racing Components
Products. We firmly believe that
Worx Racing
Components
Products are among the finest watercraft parts available.
A great deal of time and effort has gone into the design and development of this product to ensure that it will
perform to the highest standard and that installation is a relatively straight forward and simple procedure.
If you have any questions or comments on the performance and/or installation of our products, please contact us at
the above numbers.
Please note
– Damage may occur to this grate if installed and used on a personal water craft that exceeds 80 mph. It
is advised that caution be taken if installing on a watercraft exceeding 80 mph. Constant and regular checks of the
condition of the grate is highly recommended for craft exceeding 80 mph. If the condition of the grate has been
compromised in any way please remove immediately. Damage or injury to the grate, personal watercraft or persons,
is the responsibility of the installer of this grate.
RIDE SAFELY PROTECT OUR ENVIROMENT
AND RESPECT OTHERS WHO SHARE OUR WATERWAYS
