12
5. operatInG proceDures
Check the oil level before each operations as outlined on page 9. Never
change the accelerator position which is set at the factory.
5.1. startInG the enGIne
•
Open the fuel cock.
•
Pull the choke knob to close if the engine is cold.
•
If electrical starter, put the key switch in start position (START).
•
After the engine started, return the choke knob gradually
to “OPeN” position.
.
[recoIL starter MoDeL]
•
Pull the starter handle slowly until resistance is felt. This is
the «compression» point.
•
Return the handle to its original position and then pull swiftly.
If the engine fails to start after several attempts, repeat above
procedures with choke knob returned to open.
•
Do not fully pull out the rope.
•
After starting, allow the starter handle to return to its original
position while still holding the handle.
After the engine started, return the choke knob gradually to “OPeN” position.
Warm up the engine without a load for a few minutes.
