Worldlawn KING COBRA WYK52FX801V5, Руководство оператора, Страница: 36 / 48

36
appropriate direction until the wheels slightly
creep in reverse. See figure below. Move the
motion control levers to the reverse position
and while applying slight pressure to the lever
allow the RTN springs to bring the levers back
to neutral. The wheels must stop turning or
slightly creep in reverse.
8. Shut off unit. Remove jumper wire from wire
harness and plug connector into seat switch.
9. Remove the jack stands
10. Raise the deck and re-install the height of cut
pin.
11. Check that the machine does not creep in
neutral with the park brakes disengaged.
NEUTRAL ADJUSTMENT
If the hydro RTN requires adjustment, please refer
to the appropriate Hydro Gear service manual for
adjustment procedure.
MOTION CONTROL DAMPER ADJUSTMENT
Two positions are provided for installing the forward
damper stud to the motion control assembly. The
upper hole provides less resistance, the lower
provides more
.
MOTION CONTROL NEUTRAL LOCK PIVOT
ADJUSTMENT
The flanged nut can be adjusted to obtain a more
desired motion control lever resistance
Tighten or loosen the lower flanged nut to the
desired feel.
For more resistance, tighten the flanged nut.
For less resistance, loosen the flanged nut.