ECRESO FM 100/300 W, user manual– 06/2015
Page 23
Head Office : Parc d’activites Kennedy - 20, avenue Neil Armstrong – 33700 Bordeaux-Merignac (France)
Tel +33 (0)5 57 928 928 – Fax +33 (0)5 57 928 929 –
www.worldcastsystems.com – [email protected]
To configure the transmitter using the front panel:
see section 4.2.
To configure the transmitter using the PC application:
see section 4.3.
To configure the transmitter using the embedded web site
(with Communication Pack only)
:
see section 4.4.
To use serial commands, see chapter 7.
4.2.
Using the front panel
Please refer to section 6.2 for front panel working principle.
4.2.1.
Setting the transmitter
!
The transmitter must be in local mode before parameters can be modified. Press the Local button if needed.
Set the power (in W), the frequency (in MHz) and enable the RF:
9 8 . 0 0 M H z
0 W
From the main screen, press the "Enter” key to display menus
then the “+” key until you see the TX Parameters menu.
9 8 . 0 0 M H z
0 W
-> T X P A R A M E T E R S >
1
F R E Q
P F W D
->
9 8 . 0 0
0
Once you see this screen, press “Enter”
You may now set the frequency and the power. The arrow
preceding the frequency indicates that this parameter is
selected: press “Enter” to switch to edit mode.
1
F R E Q
P F W D
->
9 8 . 0 0
0
Using the “+” and “–” keys, adjust the frequency starting with
the last digit. Once you’ve reached the desired value, press
“Enter” to go to the next digit. Follow the same procedure for
all digits and confirm with the “Enter” key. Use the "+" to go the
next screen.
1
P W R
P F W D
P R E F
-> 1 0 0
1 0 0
5 2
The arrow now appears before the power: set the power in the
same way you set the frequency.
After confirming the power value with the “Enter” key, enable
the RF using the front panel button.
1
G O
T O
M A I N
-> R F
Press the “+” key until you see this screen. When the RF menu
is selected, press “Enter” to return to the list of menus.
