Page 4
Step 1
Assembly Steps
Step
2
.
Step 1
(
H-
1)
Short Allen Bolt
A
D
D
(
H-
1)
x 2
90%
Allen key
(
H-
7)
(
H-
2)
Medium Allen Bolt
Allen key
(
H-
7)
(
H-
3)
Barrel Nut
(
H-
8)
Spare Allen Bolt
B
B
C
x 2
(
H-
2)
(
H-
7)
(
H-
3)
(
H-
8)
90%
IMPORTANT:
It is highly recommended to have a second person to assist during this product assembly.
Do not fully tighten allen bolts until all components are in place. Do not over tighten allen bolts.
Using a second person to assist you, place Bench Top (A) upside down onto a padded, non-marring surface.
over the metal frame on the underside of Bench Top (A). Secure both Upper Wood Support Bars (D)
Next, position both Upper Wood Support Bars (D) as shown, making sure the notches at the ends of both bars attach
using Short Allen Bolts (H-1) and Flat Washers (H-9).
TOP
TOP
HINT:
Thread spare Allen Bolt (H-8) into the
end of Barrel Nut (H-3) to keep the barrel thread aligned.
Remove the spare Allen Bolt (H-8) when you're done.
(used temporarily)
.
Arrange both Legs (B) with the tops facing downwards as shown. Attach Lower Wood Crossbar (C) to Legs (B)
and secure both sides by attaching a Medium Allen Bolt (H-2) and Flat Washers (H-6) into a Barrel Nut (H-3).
Use Spare Allen Bolt (H-8) threaded into Barrel Nut (H-3) to hold the threads aligned while engaging
Medium Allen Bolt (H-2). Engage Medium Allen Bolts (H-2) using Allen Key (H-7)
but do not fully tighten them yet.
Once Barrel Nuts (H-3) have been engaged, remove the spare Allen Bolt (H-8).
(
H-
9)
Flat Washer M6
(
H-
9)
Engage the bolts usingAllen Key (H-7)
but do not fully tighten them yet.
(
H-
6)
Flat Washer
(
H-
6)
