World Cat 330TE 2013, Руководство пользователя

Страница: 56 / 101

2014 World Cat 330TE Owners Manual
Macerator pumps are self priming, but are susceptible to damage during extended dry runs. For this reason, the
pumps are equipped with a thermal switch. The switch will cycle the pump “OFF” to prevent damage from excessive
heat caused by dry operation. If you have a pump cut “OFF” during operation, all the unit at least 15 minutes to cool
before attempting to use it again. While you wait, verify the contents of the affected box to be certain you have not
emptied them or there are obstructions at the drain preventing the flow of material.
NOTICE
In the event the macerator pump will not prime, use the raw water washdown to spray pressurized water
into the fishbox drain. Doing so will facilitate priming of the pump.
10.2.7 Wiper w/Rinse
The windshield wiper switch allows you to operate the wiper and rinse on your windshield the switch has an
intermertimt setting and also a setting for slow speed and fast speed. To activate the wiper rotate the knob clockwise.
There are three settings.
1. Intermertimt
2. Slow
3. Fas
t
To activate the rise the freshwater rocker switch located on the dash must be in the on position. Push the wiper
switch knob in at anytime the wiper is motion.
10.2.8 Marine Head
Your 330TE comes equipped with a marine head on the portside of the forward berth. The control panel for the head
is located on the head instrument panel located on the aft vertical wall opposite the toilet. Power is supplied to this
panel through a 20 amp fuse located in the console on the accessory fuse block. The panel controls the water level in
the bowl and discharge of waste from the head.
Water is supplied to the system from the freshwater tank located in the console. To operate the toilet the freshwater
system must be pressurized. A solenoid, installed near the head inlet, prevents water from filling the bowl prior to
each use. The macerator pump, located at the rear of the toilet, removes waste from the bowl and pumps it into the 15
gallon holding tank.
! ! ! ! ! ! W W A A R R N N I I N N G G
If the solenoid fails or becomes locked in the open position, shut off the supply system quickly and
evacuate the bowl.
The holding tank is mounted in the port hull in the anchor rope locker compartment and can be accessed through the
anchor locker lid. This tank can be evacuated using the deck pump-out fitting located forward of the port berth
entrance or by overboard discharge using the macerator pump and seacock supplied on your vessel. To access the
seacock, open the inspection hatch installed in the port gunwale. Open the seacock and use the keyswitch on the head
switch panel to evacuate the tank.
1.1.1.1.Initial Start Up
Page 10-55