21. TROUBLESHOOTING
21.4 Reset to Factory Default
You can reset the GIS 320 to its factory default state with the pin button. Press the pin button for more then 5
seconds. The LED should start blinking rapidly. Do not unplug the GIS 320 from power source during this process!
Factory default can help in some situations. Typically if some settings or update caused the GIS 320 to stop
displaying the image or other minor things like going back to previous working firmware version.
Factory default will not work if the LED is not emitting light.
21.5 Remote Control
When selecting the TRIGGER mode for a digital input, make sure that the selected input is not connected to your
remote controller with PWM output. Otherwise, the TRIGGER input will not behave as expected.
21.6 System Update
Make sure that your GIS 320 version is up to date. You can find information about the current version on
https://www.workswell‐thermal‐camera.com/firmware‐update/
E‐mail and Web
[email protected]
www.workswell.eu
Mobile:
+420 725 877 063
ID:
Reg. No.: 29048575
VAT No.: CZ29048575
Headquarters
U Albrechtova vrchu 12
155 00, Prague 13
Czech Republic
Revision 210427 EN, 27
th
Apr, 2021
All pictures are only for illustration.
Real values may vary.
69
