Maintenance
3730 E. Southern Avenue, Phoenix, AZ 85040 USA
800-778-8779
Workhorseproducts.com
14
Replacing the Bulbs (Continued)
2. Open the shutter. Fully opening the shutter will
allow the shutter to operate properly after the
lamp has been replaces and power is reconnected
to the light source.
3. Locate the two wire leads supplying power to
the lamp.
4. Disconnect each lead from the
front and rear of the lamp as
shown.
5. Before reattaching the wire
leads use alcohol pad to clean the
lamp and reflector panel. While
holding the lamp with a paper
towel or cloth to maintain
cleanliness, press the ends of the
lamp into the clips. Reconnect
the two wire leads.
Do not touch the lamp during installation. Any contamination transferred to the lamp may cause premature failure.
6. Do not reposition the shutter
manually. The shutter will actuate
automatically when power is
restored to the PhotoSharp. Once
the lamp has been cleaned and
properly installed close the
bottom drawer and fasten the two
screws
