Manual 37615C
SPM-D2-10 - Synchronizing Unit
© Woodward
Page 35/68
Push Buttons
≡≡≡≡≡≡≡≡≡≡≡≡≡≡≡≡≡≡≡≡≡≡≡≡≡
Configuration may be performed by manually inputting the desired set points utilizing the pushbuttons and the LC
display. In order to facilitate configuring the parameters, the push buttons have been enabled with an
AUTOROLL function. This permits the user to advance to the next setting, configuration screen, digit, and/or
cursor position more rapidly by pressing and holding the corresponding pushbutton.
12
Display / Select
Display / Select
Automatic mode:
Display - By pressing this button, the user may navigate
through the displayed measured parameters and alarm messag-
es.
Configuration:
Select - Advances the LC display to the next configuration
screen. If any values in a configuration screen have been modi-
fied with the "Digit
" or "Cursor
", then the "Select" button
must be pressed to save the new setting. By pressing this push-
button again, the user causes the system to display the next
configuration screen.
13
Digit
Digit
Automatic mode:
Digit
- no function
Configuration:
Digit
- Numerical values over the cursor are increased by
one digit. The increase is restricted by the admissible limits (re-
fer to the list of parameters included in the appendix). If the
maximum admissible number is reached, the number automati-
cally returns to the lowest admissible number.
14
Clear / Cursor
Clear / Cursor
Automatic mode:
Clear - Alarms that have occurred may be acknowledged
by pressing this button as long as the fault that triggered the
alarm is no longer present.
Configuration:
Cursor
- This button moves the cursor one position from
left to right. When the cursor is under the last digit that may be
changed, it may be moved to the first number of the value by
pressing the "Cursor
" button again.
