Woodward easYgen-3000XT Series, Руководство пользователя, Страница: 627 / 1205

Thermocouple device (750-458) for voltage measurement
There is no intuitive setting in the easYgen-XT if a channel of the Thermocouple (TC)
device (750-458) is configured for voltage measurement. But nevertheless it is possible.
Therefore a special scaling of the easYgen-XT parameters “Sender value at display min.”
and “Sender value at display max” is required like described in the table below:
Voltage measuring range “Sender value at display
min.” “Sender value at display max.”
+/- 30 mV -614.4 614.4
+/- 60 mV -307.2 307.2
+/- 120 mV -153.6 153.6
4.7.4.2.2 J1939 Interface
General notes
For additional information refer to ╚═▷ “7.5 J1939 Protocol” .
Parameter 15102 »Device type « allows to select an ECU either by name or - for even
more flexibility - via an ECU file; then the name of the preferred ECU file must be entered
into parameter 15167 »ECU file name«. Please ask your local Woodward partner for
further information.
ID Parameter CL Setting range
[Default]
Description
15166 J1939 2 Off The J1939 interface is
disabled. No messages will
be received or transmitted.
[On] The J1939 interface is
enabled.
The J1939 interface of this
device may be operated
with different engine
control units or analog
input devices. J1939 values
(e.g. from an ECU) can be
received and indicated
15102 Device type 2 The J1939 interface of this
device may be operated
with different engine
control units or analog
input devices.
This parameter determines
the type of the used ECU or
that a special ECU file
designed for an ECU which
627 easYgen-3000XT Series B37574
4 Configuration
4.7.4.2.2 J1939 Interface
Released