Woodward easYgen-3000XT Series, Руководство пользователя, Страница: 577 / 1205

Parameter
Navigate to [Parameter / Configuration / Configure monitoring / Miscellaneous / Other
monitoring / PV load reference].
ID Parameter CL Setting range
[Default]
Description
8923 PV disconnect level 2 -20.0 to 20.0%
[-2.0%]
This is the system generator load
level on which the PV is
immediately to cut.
(Hysteresis is 0.5%.)
8924 Delay 2 0.1 to 99.0 s
[5.0 s]
If the system generator load level
underruns the disconnect level for
the delay time the alarm is
tripped.
(The delay off time is 0.08s.)
8925 Alarm class 2 Class A, Class B, Class C, Class D,
Class E, Class F , Control
[Class B]
Each limit may be assigned an
independent alarm class that
specifies what action should be
taken when the limit is surpassed.
Notes
For additional information refer to
╚═▷ “9.5.4 Alarm Classes”
8926 Self acknowledge 2 Yes The control unit automatically
clears the alarm if the fault
condition is no longer detected.
[No] The control unit does not
automatically reset the alarm
when the fault condition is no
longer detected.
The alarm must be acknowledged
and reset by manually pressing
the appropriate buttons or by
activating the LogicsManager
output "External
acknowledgment" (via a discrete
input or via an interface).
4.5.6.16 Multi-Unit Parameter Alignment
General notes
The multi-unit parameter alignment functionality requires that the relevant parameters
are all configured identically at all participating units.
If at least one of these parameters is configured different in at least one of the units, the
display indicates "Parameter alignment" on all units and the logical command variable
"08.16" will be enabled. To identify different configured units, please use the diagnostic
screen "Genset parameter alignment":
HMI: [Next Page / Multi-unit / Genset parameter alignment]
ToolKit: [STATUS MENU / Multi-unit / Genset parameter alignment]
577 easYgen-3000XT Series B37574
4 Configuration
4.5.6.16 Multi-Unit Parameter Alignment
Released