Woodward easYgen-3000XT Series, Руководство пользователя, Страница: 527 / 1205

ID Parameter CL Setting range
[Default]
Description
If the monitored df/dt exceeds the
threshold (plus the hysteresis)
again before the delay expires the
time will be reset.
3101 Alarm class 2 Class A, Class B, Class C, Class D,
Class E, Class F , Control
[Class B]
Each limit may be assigned an
independent alarm class that
specifies what action should be
taken when the limit is surpassed.
Notes
For additional information refer to
╚═▷ “9.5.4 Alarm Classes” .
3102 Self acknowledge 2 Yes The control automatically clears
the alarm if the fault condition is
no longer detected.
[No] The control does not automatically
reset the alarm when the fault
condition is no longer detected.
The alarm must be acknowledged
and reset by manually pressing
the appropriate buttons or by
activating the LogicsManager
output "External
acknowledgment" (via a discrete
input or via an interface).
3103 Enabled 4 [Always] Monitoring for this fault condition
is continuously enabled.
87.70 LM:Eng.mon Monitoring for fault conditions is
not performed until engine
monitoring is enabled. This is
determined through the
LogicsManager equation "Release
engine monitoring".
For xx = 1 to 32:
96.{xx}
LM: Flag{xx}
Defining of an own release flag
through Logicsmanager equations.
FRT ROCOF enable The dynamic mains stabilization
according to VDE-AR-N 4110/4105
requires a temporary blocking of
the ROCOF monitor. Please refer
to the according VDE-AR-N rule.
527 easYgen-3000XT Series B37574
4 Configuration
4.5.3.12 Change Of Frequency
Released