Woodward easYgen-3000XT Series, Руководство пользователя, Страница: 207 / 1205

ID Parameter CL Setting range
[Default]
Description
This LogicsManager is only used if
the "start/stop mode logic" is
configured to Diesel in
combination with "preglow mode"
Always or Analog.
An active preglow mode will be
interrupted if the LogicsManager
becomes active.
3309 Preglow temperature
threshold
(Diesel engine only)
2 -10 to 250 °C
[0 °C]
This is the temperature threshold,
which must be exceeded to
prevent a preheating process, if
parameter
╚═▷ 3347 has been set
to "Analog".
3346 AM Preglow criterion
(Diesel engine only)
2 Determined by AnalogManager
81.01
[A1 = 10.01 ZERO]
The preglow criterion may be
selected from the available data
sources.
Usually, a temperature measuring
is selected here, which is
measured via a sensor.
Notes
Refer to ╚═▷ “4.9.1 Operations”
for explanation how to use the
AnalogManager.
Refer to ╚═▷ “9.4.2 Data Sources
AM” for a list of all data sources.
4057 Pre-excitation D+ 2 [On] When the engine is starting up, an
exciting current is issued.
Notes
The resulting voltage at terminal
65 can be monitored. Refer to
chapter
╚═▷ “4.5.2.7 Engine
Charge Alternator (D+)” for
details.
Off No exciting current is issued. The
input D+ can be used as analog
input which can be configured
freely e.g. for (firing) speed
detection.
Notes
This function is only working if the
battery voltage is below 27.5 V to
avoid overload of internal circuitry.
4058 Pre-excitation D+ off
delay 2 0 to 10 s
[0 s]
Defines the active (waiting) time
of the Analog Output »Pre-
excitation D+« after starter time
has exceeded.
Notes
This fallback time of the pre-
excitation enables to hold the pre-
excitation longer than starter
time.
207 easYgen-3000XT Series B37574
4 Configuration
4.4.1.1 Configure Engine (general)
Released