Woodstock Shop Fox W1888, Руководство пользователя

Страница: 79 / 97

-76-
Model W1888 (For Machines Mfd. Since 10/20)
SE
RV
IC
E
Table/Dado.Insert.
Adjustment
The table/dado insert must sit perfectly flush with the
table to provide a smooth, continuous surface for the
workpiece to slide over. The insert is held in place by
a magnet and sits on top of four adjustment screws
(see Figure 120 ).
The insert should be checked and adjusted any time it is
removed and replaced, after prolonged use, or any time
you notice the workpiece or fence does not slide smoothly
over the insert.
Tools.Needed. Qty
Hex Wrench 3mm ...............................................1
Straight Edge ....................................................1
To.check.and.adjust.insert,.do.these.steps:
1. DISCONNECT MACHINE FROM POWER!
2. Place straightedge across insert and check to make
sure insert is flush with table at front and back of
throat.
— If insert is flush with table, no adjustments are
necessary.
— If insert is not flush with table, proceed to Step 3.
3. Insert hex wrench through holes shown in Figure
120
. Loosen screws to raise insert, or tighten screws
to lower it.
4. Repeat Steps 2–3 until insert is perfectly flush with
surface of table.
Note:
Table insert should be firmly installed (should
not rock) in the table. Each screw should support
insert evenly.
Figure 120 . Location of table/dado insert
holes with adjustment screws.