WOOD'S POWR-GRIP MRTALPR4FS10TDC, Инструкция по эксплуатации

Страница: 33 / 46

Rev 11.3/1-17 31 MRTALPR4-DC: #35057
T
O
R
EPLACE
S
EALING
R
ING IN
VPFS10T V
ACUUM
P
AD
1) Remove the old sealing ring insert: Hold the vacuum pad firmly and pull the ring insert out
from the mounting groove. Discard any damaged ring insert.
2) Install a new sealing ring insert (see REPLACEMENT PARTS LIST): Make sure the entire
vacuum pad is clean, including the mounting groove (see V
ACUUM
P
AD
M
AINTENANCE
: Cleaning
preceding). Push the ring insert into the mounting groove so that the insert's base (flat side)
fits flush against the bottom of the groove. Begin by placing the inside edge of the ring
insert against the inside edge of the mounting groove. Then push gently and firmly on the
outside edge of the ring insert until it seats completely into the mounting groove. A pad ring
installation tool is available to facilitate this process (see REPLACEMENT PARTS LIST). Work
your way around the entire ring insert, repeating this process until the entire ring is seated in
the mounting groove.
3) Make sure that the sealing ring is secure and fully inserted into the mounting groove around
the entire perimeter of the vacuum pad.
Note: If the ring insert ever comes partially or entirely out of the mounting groove, inspect the
ring insert for damage and reinstall an undamaged ring insert according to preceding directions.