woodmizer LT70M AH Super, Руководство пользователя

Страница: 72 / 142

MAINTENANCE
Blade Guides
3
3-2 HDSdoc021716 MAINTENANCE
3.2 Blade Guides
1. Check the rollers for performance and wear every blade change. Replace any rollers which have worn
smooth or have become cone shaped. Make sure the rollers are clean and spinning freely. If not, rebuild
them.
Steel Guide Blocks
2. Inspect the blocks at every blade change for damage or wear.
As the blocks wear, the front inside corner will wear more than the body of the block. When the corner wears
far enough, sawing performance will be affected even if the body of the block is adjusted properly to the
blade. At this point, the block should be replaced. If you have access to the appropriate equipment, you can
grind or mill the blocks to a new flat surface and reuse them. It is recommended you develop a routine
schedule for replacing the blade guide blocks based on your sawing conditions and experience.
3. Check the inserts are properly spaced from the bottom of the blade every 25 hours of operation. As the
rollers wear, the gap between the blade and inserts will become larger. Use the provided shim or a feeler
gauge to check the inserts are adjusted 0,3 - 0,5 mm from the blade.
See Figure 3-1. To adjust the disks up, loosen the bottom guide disk mounting bolt and clamp bolt. Use the
provided adjustment tool. to raise bottom disk Retighten the bottom disk mounting bolt and clamp bolt. See
Section Blade Disk Adjustment
FIG. 3-0
25