PG
9
OF
24
M0183.05 JULY 2019
Whatcom Gas-Fired Vertical Rotisserie CE
Installation and Operation Manual
Restraining Hole
Caster models
CASTER EQUIPPED ROTISSERIES
Utility hookups should be made in such a way as to allow mobility of the rotisserie
for service and maintenance purposes�
ATTENTION INSTALLER: EQUIPMENT RESTRAINT MUST BE PROVIDED
Adequate means must be provided to limit the movement of the appliance without
depending on the connector and the quick disconnect device or its associated
piping to limit the appliance movement� Use the hole located on the left rear leg of
the rotisserie cabinet to attach the restraining device(s) (see photo to right)�
COUNTERTOP MODELS
TO SECURE THE ROTISSERIE TO THE COUNTER
Remove the curb walls at the base of the unit to access the legs�
Fasten the unit to the countertop using the 9�5 mm (3/8") holes in the bottom of each leg�
Replace curb walls�
NOTE:
ALL
SIDES AND TOP OF UNIT MUST BE READILY ACCESSIBLE FOR SERVICE.
Predrilled holes in
cabinet legs to secure unit
Corner detail
Countertop
models
Front of unit
Detail: Curb Walls
q
w
e
w
INSTALLATION
