Maintenance & Alignment
Alignment
Maintenance & Alignment
PGdoc031914
3-4
3
Blade Clamp Position
NOTE:
The grinder/clamp position is set and pinned at the
factory and should not need adjusted unless the grinder is
damaged or major components replaced. If adjustment is
necessary, remove the pins, adjust then drill a new hole
and repin the assembly.
See Figure 3-3.
Remove the grinding wheel cover thumb screws and cover to access the
grinding wheel shaft.
Use the provided square socket and a socket wrench to hold the end of the grinding
wheel shaft. A hole in the drive belt cover provides access to the end of the shaft.
Loosen the top oiler mounting bolt to move the oiler out of the way. Unscrew the nut from
the grinding wheel shaft and remove the nut, flat washer and grinding wheel.
Remove the front clamp pivot bolt and the two clamp handle mounting bolts to completely
remove the front clamp from the grinder. Loosen the blade rest pin locking set screws and
push the pins back (pivot the left pin stop plate out of the way). Disassemble the clamp
wear block from the back clamp plate.
FIG. 3-3
Remove grinding wheel
and oiler
Remove front
clamp
Push blade
rest pins back
Remove clamp
wear plate
PG0005-12
Clamp Handle
Mounting Bolts
Clamp Pivot
Bolt
Locking Set
Screw
