SETUP & OPERATION
MP160 planer/thicknesser operation
EGdoc072921
3-3
3
3.2
MP160 planer/thicknesser operation
3.2.1 Control panel
See figure 3-1.
MP160 planer/thicknesser controls are shown below:
Top red button (A) - the emergency stop switch, which disconnects power to all functions. When the
emergency stop switch is pressed, it must be released before restarting the planer/thicknesser (turn
right).
Over the emergency stop switch there is an indicator light (B) which indicates that the power is on.
When replacing knives and servicing, the power On/Off switch (C) must be in the off position and
power supply cable must be disconnected. Check if indicator light (B) is off.
The white button (D) starts the planer's cutter and feed motors. The black button (E) stops these
planer's motors.
FIG. 3-1
A
B
C
D
E