Wood-mizer LT15WB D17, Инструкция по безопасности, установке, эксплуатации и техническому обслуживанию

Страница: 50 / 88

Setup & Operation
Transporting the Sawmill
2
2-17 doc071918 Setup & Operation
2.15 Transporting the Sawmill
The assembled sawmill can be manually loaded into and transported in an appropriately equipped
pickup truck:
WARNING! A minimum of three people (four recommended) is required to safely
load or unload the sawmill from a pickup truck. Failure to follow this may result in
serious injury or death.
The sawmill weighs 1100 lbs. (500Kg). The center of gravity of the carriage is
off-center toward the operator side. The higher the saw head from the bed frame,
the more easily the mill can be tipped toward the operator side.
WARNING! Ensure the carriage lock pins are properly engaged. Failure to follow
this may result in serious injury or death.
To prevent the carriage from unexpectedly sliding on the rails, the pin at the end of
the sawmill
must engage the hole in the bed frame . The other pin must be left in
the operation position.
1. Remove the leg assemblies or adjust them above the bottom of the bed frame.
See Figure 2-7.
See Section 3.5
for a detailed description of carriage lock pin operation.
FIG. 2-7
150210-21B
DETAIL
Be Sure Lock Pin Engages
Hole In Frame Tube
Lock Pin At End
Of Sawmill In
Travel Position
(See Detail)
Lock Pin In
Operation
Position