LubeMizer Installation
Finishing Steps
1
1-17
LMS99doc032619
LubeMizer Installation
1.7
Finishing Steps
1. LT30/LT40 Only:
Reinstall the drive side blade housing cover and left pan cover.
DANGER!
Make sure all guards and covers are in place
and secured before operating or towing the sawmill. Failure
to do so may result in serious injury. Be sure the blade
housing and pulley covers are in place and secure. Use the
safety retainer pin and cable to fasten blade housing cov-
ers.
2.
Reconnect the negative battery terminal cable and replace the battery box cover.
3.
Align the inner blade guide assembly as instructed in the alignment section of your
Wood-Mizer Operator’s Manual. After blade guide alignment, be sure to check the scale
indicator to make sure it is adjusted properly (procedure also found in the alignment sec-
tion of your Wood-Mizer Operator’s Manual).
4.
Fill the water lube bottle with clean water. Avoid using water that might contain foreign
substances such as algae, dirt or minerals that can damage the pump or clog the check
valves.
