Setup & Operation
Transporting The Edger
3
3-10
SBEdoc072519
Setup & Operation
3.4
Transporting The Edger
Follow these steps to transport the Edger in a pickup truck (minimum 8’ bed required):
WARNING!
When setting up or transporting the Edger,
avoid areas marked as pinch points. These are located
near the rear folding legs and the engine pulley. Keep your
hands away from these areas to prevent injury.
1.
Make the Edger lighter and more portable by removing the engine. To remove, disconnect
the clutch linkage from the motor mount pin and remove the lock pins from the Edger
U-brackets. Lift the engine up and remove it from the Edger. Reinstall the lock pins into
the U-brackets.
2.
Back the truck to the rear of the edger until the truck bed is positioned under the rear of
the Edger frame. Lift the weight from the rear Edger leg and fold the leg up to the Edger
frame, allowing rollers at the rear of the Edger to rest on the bed of the truck.
3.
Slide the Edger into the truck. Secure as necessary for transport.
