Wood-mizer EG400EH30S, Руководство пользователя

Страница: 62 / 133

Setup & Operation
Setworks Operation
3
3-16 IE doc122719 Setup & Operation
3.6 Setworks Operation
Setworks option allows the operator to quickly and easily set the distance between the
blades by selecting one of the board width values programmed at the factory. Each value
can be modified and saved by the operator. The figure in the first line on the display
indicates the current distance between the blades. The operator can at any time change
the distance between the blades "manually", using the blue blade adjustment buttons.
Pressing either of the blade adjustment buttons disables Setworks and enables manual
adjustment of the blades. Selecting the board width memory again will activate the
Setworks and the distance between the blades will be automatically adjusted.
NOTE: During cutting operation, the distance between the blades cannot be changed
either manuallyt or automatically.
BOARD WIDTH PROGRAMMING
Six board width dimensions can be programmed using the six MEM buttons located on
the Setworks control panel (MEM1 through MEM6). They can be modified with the UP or
DOWN arrow buttons. For example, in order to reprogram the MEM1 dimension, first
press the MEM1 button and hold it for about 3 seconds. Then use the UP or DOWN
arrows to scroll to the desired setting (pressing the arrow button once changes the
dimension by 1 mm; to scroll faster, hold the arrow button for about 2.5 seconds). To store
the new setting and exit the settings menu, press and hold the memory button for 3
seconds. Once the button is released, the Setworks will automatically set the blades as
desired.
NOTE: If more than one dimension was reprogrammed, there is no need to save each
dimension separately. Pressing any of the memory buttons for 3 seconds stores all
reprogrammed dimensions.
NOTE: The operator cannot program the board width dimensions beyond the maximum
and minimum board width limits set at the factory. These limits cannot be changed by the
operator.