Wood-mizer EG100EH11S, Руководство пользователя

Страница: 34 / 82

INSTALLATION
Adjustment of the Cutting Width Setting System
3
3-12 EGdoc020420 Operation
3.2.4 Adjustment of the Cutting Width Setting System
6. Toothed Bar Adjustment
To position properly the toothed bar:

Place a 100x100 (4”x4”) block between the blades. Clamp the block by moving the blades in.
See Figure 3-11.

Loosen the nuts on the toothed bar mounting bolts (see the figure below).

Again, clamp the block by moving the blades in.

Position the toothed bar so that the pawl tooth each time enters a cut-out between the teeth of
the bar.

Tighten the nuts on the toothed bar mounting bolts.

Remove the block.
FIG. 3-11