Wood-mizer A/DH5, Инструкция по безопасности, установке, эксплуатации и техническому обслуживанию

Страница: 45 / 134

SETUP & OPERATION
Portable Sawmill Setup
SETUP & OPERATION doc111517 2-11
2
See Figure 2-9. The figure below shows how the cable hanger should be set.
Unbolt the four bolts, rotate the hanger 90 degrees to the right and tighten the bolts.
2.3 Portable Sawmill Setup
WARNING! If it is necessary to set up the sawmill on ground with more
than 3
o
incline, dig out areas for outrigger legs to prevent the sawmill
from tipping over.
WARNING! Chock the trailer wheels to prevent movement before
unhitching it from the towing vehicle. Failure to do so will result in
serious injury or death.
1. Pull the hand brake to prevent the sawmill from moving.
1. Unhitch the mill from the vehicle.
2. Lower and set the front fine adjust outriggers. To do this, first manually pull the locking pin out of the
outrigger hole. When the outrigger contacts the ground, release the pin. Then using a 19 wrench,
turn the outrigger adjustment bolt until the locking pin enters the nearest outrigger hole.
WARNING! Put front outrigger down before moving cutting head from
the rest position. Failure to do so may result in serious injury.
FIG. 2-4
1
2