WON TECH WON COSJET ATR S, Руководство пользователя

Страница: 53 / 55

User Manual
WT-UM-08 (v4.4)
53/55
APPENDIX 1
Guidance and manufacturer’s declaration – electromagnetic immunity
Standards Test level
Compliance
level
Electromagnetic
environment-guidance
EN 55011:
2009 + A1:
2010(Class
A, Group 1)
Mains terminals
continuous
disturbance
voltage 0.15MHz~30M
Hz 0.15MHz~30M
Hz
The EUT was placed on a
wooden table, 0.1m height
above the floor. The EUT was
connected to adaptor and the
power of adaptor was fed to
the EUT through a 50Ω/
50µH + 5Ω Artificial ains
Network(AMN)
The
ground plane was
electrically bonded to the
reference ground system and
all power lines were filtered
from ambient.
Radiated
electromagnetic
field
30MHz~1000M
Hz 30MHz~1000M
Hz
The radiated emissions
measurements were on the
ten-meter, open-field test site.
The EUT was placed on a
non-conductive
turntable
approximately 0.1 meters
above the ground plane.
EN 61000-3-
2:2006
+
A2:2009
Voltage changes,
voltage
fluctuations
and
flicker
220V-230VAC 220V-230VAC
The voltage changes at the
supply
terminals were
measured across the complex
reference
impedance
Z=0.4+J0.25ohm. The short-
term
flicker values are
measured during a time
interval of 10 minutes.
EN 61000-3-
3: 2008
Voltage changes,
voltage
fluctuations
and
flicker
220V-230VAC 220V-230VAC
The voltage changes at the
supply
terminals were
measured across the complex
reference
impedance
Z=0.4+J0.25ohm. The short-
term
flicker values are
measured during a time
interval of 10 minutes.
EN 60601-1-
2: 2007
Electrostatic
discharge
immunity
Contact
discharge:
2/4/6kV
Air discharge:
2/4/8kV Contact
discharge:
2/4/6kV
Air discharge:
2/4/8kV
Floors should be wood,
concrete or ceramic tile. If
floors
are covered with
synthetic material, the relative
humidity should be at least
30%.
Radiated RF E-
Field
(80 to 2500MHz)
80~2500MHz 80~2500MHz
Portable and mobile RF
communications
equipment
should be used no closer to
any
part of the WON
COSJET ATR S, including
cables, than the recommended
separation distance calculated
from the equation applicable
to the frequency of the
transmitter.