61
➢
The circuit breaker must be easily accessible.
2.3 Selection of installation equipment / Dimensions
Cut out the installation hole as described on the drawing below. For installation and
use, a minimum of 50 mm space shall be preserved around the hole. The thickness
of the work top should be at least 30 mm. Choose heat-resistant materials for the
work top only to avoid any deformation caused by the heat-radiation of the
appliance.
1. Seal
L
(mm)
W
(mm)
H
(mm)
D
(mm)
A
(mm)
B
(mm)
X
(mm)
770
520
62
58
740
490
min.50
2.4 Installation of the hob
DANGER!
The hob must be installed
by a qualified professional
only
. Do not carry out the installation yourself. RISK OF ELECTRIC
SHOCK!
❖
The hob must be ventilated properly.
The air inlet (
D
) and outlet (
E
) must
never be blocked or covered. Always keep the appliance in proper condition. The
top closing edge of the cabinet (
X
) must not be flush with the installation opening
(
1
). Install the closing edge in offset positioning (
2
) or bevel the closing edge (
3
).
