wolke m600 basic, Руководство оператора

Страница: 146 / 166

Rev AB Line Selection Faults 8-9
Wolke m600 touch Operator Manual
Line Selection Faults
CLARiTY
®
Error messages
Fault Cause Solution
Invalid Line The line selection inputs have
requested a line that is not
configured. 1. Use CLARiTY® Configuration
Manager to check that the correct
number of lines have been setup for this
system.
2. Check if the line selection inputs are
connected properly.
3. Touch the Clear button to clear this
warning message.
No Line
Selected A print signal has been received
for a product without any line
selection. 1. Check if the line selection system is
functioning correctly.
2. Touch the Clear button to clear this
fault message.
Table 8-5: Line Selection Faults
Error
No Report on CLARiTY Operator Interface Status
E1001 ‘Count Limit Reached’ - One or more of the counters in
the image has reached the end value set in the image
design. Please select a new job and touch the Clear
button to restart the printer Fault
E1002 ‘Operation Aborted’ - The operation of the printer has
been intentionally aborted by a host control system.
When ready to resume the operation, the host control
system cleared this abort condition, and then this fault
message clear automatically. Fault
E1003 ‘Real-time Clock Fault’ - There is a problem with the
real-time clock which is required for the system to
operate correctly Fault
E1004 ‘Backup Battery is Flat’ - The battery which powers the
printer's clock is flat. This means that the date and time,
the currently selected job and some performance data is
lost when the printer is switched off. Warning
Table 8-6: CLARiTY
®
Error Messages