4K IP Streaming Extender
18
5.4 Wall Routing Tab
Wall Routing tab allows for a single source (TX) to be assigned to multiple Decoder
(RX) units and loaded across multiple displays appearing as a single wall. Figure below
illustrates the Wall Routing tab. The top portion is reserved for configuring and setup of
the Wall, while the bottom half lists all available TX (Encoder) and RX (Decoder) units.
The wall size can be adjusted by changing the number of rows and columns. Bezel
correction values are in number of image pixels. The default value is set to 16 pixels.
Increase this value to adjust for thicker bezels while a value of zero would indicate no
bezel correction is to be applied.
Note:
Source must be progressive.
5.4.1 Configuring a Video Wall
1) Set the Wall Size.
a) Under the Wall Parameter section enter the number of Rows and Columns that
are to make up the Video Wall (maximum 5x5).
2) Drag and drop Decoder devices onto individual wall decoder tiles.
a) From Wall section, left click on it to select one tile.
b) Drag and drop decoder device onto the blank tile on the Wall Decoders.
3) Next drag an encoder source tile and drop it onto the tile that is labeled Wall: Drag
Here To Use Wall.
