WOLFF GmbH & Co. KG | D-74360 Ilsfeld | Ungerhalde 1 | Tel. +49 (0)7062-91556-0 | Fax +49 (0)7062-91556-10 | E-Mail [email protected] |
Internet
www.wolff-tools.de
8
45° Cut
Adjust the angle
attachment to 45°. Insert
material between the
cutting blade and the base,
against the angle
attachment as shown, then
press the handle down to
complete a cut.
Warning:
Maintain control
of the handle. Do not allow
handle to slam back after
making a cut.
Changing the Blade
Use the
provided Allan
wrench to remove the ten
screws, then hold the blade
by each end and carefully
move the blade out of blade
holder.
Note:
the flat side of the
blade should face the
working table when install a
new blade.
Warning:
Do not put your
fingers against the sharp
edge of the blade at any
time.
